diff --git a/CHANGELOG.md b/CHANGELOG.md
index 816ae1e5a..d949d468b 100644
--- a/CHANGELOG.md
+++ b/CHANGELOG.md
@@ -10,6 +10,11 @@ upstream MeshCore `dev` branch, which generally pulls in a new MeshCore software
 
 ### August 2026
 
+- **New** — Analytics dashboard on the Heltec V4 R8 Expansion Kit V2 TFT: 20-minute rolling RF activity with a packets-per-minute graph, on a dark padded layout that repaints only the rows that changed  <sub>2026-08-28</sub>
+- **New** — `display.timeout` (blank after N seconds, 0 = always on) and `display.flip` (rotate 180 degrees), both applied live  <sub>2026-08-28</sub>
+- **New** — Tap the Expansion Kit V2 panel or press USER to blank/wake the display; hold USER 3 s to power off  <sub>2026-08-28</sub>
+- **Fix** — Power-off on the V4 R8 armed an RF wake, so a node in live traffic rebooted seconds after showing "Turning OFF"  <sub>2026-08-28</sub>
+- **Fix** — The V4 R8 TFT could not be woken once blanked, because waking re-ran a full panel init that also reset the touch controller  <sub>2026-08-28</sub>
 - **New** · `platformio` — MQTT observer repeater and room-server configs for Heltec V4 R8 (OLED and TFT)  <sub>2026-08-20</sub>
 
 ### June 2026
diff --git a/docs/cli_commands.md b/docs/cli_commands.md
index 057fc0e2a..0c4ddf6ac 100644
--- a/docs/cli_commands.md
+++ b/docs/cli_commands.md
@@ -662,6 +662,37 @@ Elsewhere it replies `Err - neighbors not enabled in this build`. If a
 
 ---
 
+#### View or change the display timeout
+**Usage:**
+- `get display.timeout`
+- `set display.timeout <seconds>`
+
+**Parameters:**
+- `seconds`: `0` to keep the display on permanently, or `1-3600` seconds of inactivity before it blanks
+
+**Default:** `60`
+
+**Note:** Observer builds with a display only. The change applies immediately and restarts the
+countdown. Tap the panel or press the USER button to wake or blank it by hand.
+
+---
+
+#### Rotate the display 180 degrees
+**Usage:**
+- `get display.flip`
+- `set display.flip <state>`
+
+**Parameters:**
+- `state`: `0`/`off` (as built) or `1`/`on` (rotated 180 degrees)
+
+**Default:** `0`
+
+**Note:** Observer builds with a display only, for a board mounted the other way up. This is
+persisted config, so it survives a firmware update - a node that looks upside down after an
+update may simply still be carrying `display.flip 1`. The boot log reports the current state.
+
+---
+
 #### Enable or disable Multi-Acks support
 **Usage:**
 - `get multi.acks`