Five "Default:" values in cli_commands.md no longer matched the firmware:
- radio / freq: the default preset moved to EU/UK (Narrow) in b777a7c6,
changing LORA_FREQ/BW/SF from 869.525/250/11 to 869.618/62.5/8
(platformio.ini:29-31). No variant overrides these, and LORA_CR is 5
on every path, so the full preset is 869.618,62.5,8,5.
- flood.advert.interval: raised to 47 hours in 40180b8f for both repeater
and room server; sensor leaves it disabled.
- advert.interval: prefs store minutes/2 and the getter doubles on read, so a
factory-fresh node reports 2, not 0. But savePrefs() zeroes any interval
below the 60 minute minimum (CommonCLI.cpp:162-165), and it is called from
every `set` handler -- so the value becomes 0 as soon as the node is
configured. Documented both states, since neither alone is the whole story.
- direct.txdelay: repeater defaults to 0.3, room server and sensor to 0.2.
Sources: platformio.ini:29-31, simple_repeater/MyMesh.cpp:893,903-904,
simple_room_server/MyMesh.cpp:650,661-662, simple_sensor/SensorMesh.cpp:716,
726-727, CommonCLI.cpp:162-165,680-681.
PA PL1 re-targets the PA's DC-DC supply rail rather than selecting a
logic-level gain, and the serial CLI is serviced on every main-loop pass
regardless of whether a transmit is in flight. A `set radio.fem.txgain`
write could therefore move the rail mid-transmit, while the SX1262 was
still driving the PA at full input power.
Record the requested level in setPAGainEnable() and drive the pin from
setTxModeEnable(), which runs from onBeforeTransmit() ahead of
startTransmit(). The level only matters while transmitting, so deferring
costs nothing.
Document that the pref is saved immediately but applied at the next
transmit, so `get radio.fem.txgain` can lead the hardware until then.
Extract the inline cursor-walk in handleRegionCmd into file-local
helpers (skipSpaces, rtrimSpaces, takeToken, splitNameJump,
processRegionDefSegment), grouped immediately above the consumer.
Behavior is identical; addresses PR #2540 review feedback on
readability.
Tighten the region def docs: collapse five Note callouts into three
grouped paragraphs (Behavior / Existing regions / Limits), add a
case-sensitivity caveat plus an error example, note the cursor reset
between split commands, and use generic placeholder names.
Add a new command `region bulk` for defining region hierarchies in a single line. This command allows users to create multiple regions in a single message. Updated the documentation to include usage examples and detailed parameter descriptions.
Ben Allfree