Introduce a web configuration portal for easier node management and
provisioning without serial CLI. Enhance MQTT functionality with
improved IATA code validation, dynamic slot management, and
background NTP synchronization. Update web UI elements for better
user experience and security notes regarding open AP usage.
companion_radio has its own NodePrefs without radio_fem_rxgain (matching
upstream, which doesn't wire companion either), so the startup call added in
e905451d broke every companion build:
MyMesh.cpp:973: error: 'struct NodePrefs' has no member named 'radio_fem_rxgain'
It went unnoticed behind the pre-existing companion build failures.
Also port upstream's FEM LNA overrides for heltec_t096 and heltec_tracker_v2
verbatim (board overrides + isLNAEnabled/const getters), so all three boards
upstream wires now match instead of reporting unsupported. Both variant files
compile; those targets still fail overall on the pre-existing non-observer
MQTT-source build-config issue (unchanged with this work stashed).
Match upstream pin map (KCT8103L CSD/CTX, I2C 6/17, LORA_TX_POWER=9) and restore meshcore LoRaFEMControl.cpp and HeltecTrackerV2Board.cpp. Run ESP32 at 240MHz for MQTT/WiFi bridge headroom. Sensor env drops fork-only ENV_PIN overrides to match upstream.
Made-with: Cursor
Upstream adds LoRaFEMControl for a KCT8103L pinout; this variant uses GC1109 (P_LORA_PA_*). Reintroduce the class with the same API and wire HeltecTrackerV2Board through it so FEM logic matches platformio.ini.
Made-with: Cursor
The GC1109 FEM needs its VFEM_Ctrl pin held HIGH during deep sleep
to keep the LNA active, enabling proper RX sensitivity for
wake-on-packet. Without this, the LNA is unpowered during sleep
and RX wake sensitivity is degraded by ~17dB.
Release RTC holds in begin() after configuring GPIO registers
(not before) to ensure glitch-free pin transitions on wake.
Trade-off: ~6.5mA additional sleep current for significantly
improved wake-on-packet range.
- Updated the begin() method to handle deep sleep and cold boot scenarios for GC1109 FEM pins.
- Improved pin configuration logic for power management and transmission control.
- Enhanced comments for clarity on pin roles and behavior during sleep and wake cycles.
- Adjusted platformio.ini files to reflect updated pin definitions and usage notes.
agessaman