# Wokwi config for the ESP32-S3 observer simulation (no hardware, no flashing).
#
# Build the sim firmware first (produces the merged flash image Wokwi needs):
#   pio run -e Heltec_v3_repeater_observer_mqtt_sim -t mergebin
#
# Then start the simulation either way:
#   - VS Code: install the "Wokwi Simulator" extension, open diagram.json, press play
#   - CLI:     wokwi-cli .            (needs a free WOKWI_CLI_TOKEN)
#
# The firmware is seeded to auto-join the "Wokwi-GUEST" network, so it boots
# straight into WiFi + MQTT. The LoRa radio is stubbed (SimRadio); mesh RX/TX is
# not simulated. Drive the CLI over the serial monitor (get/set/start webconfig).
[wokwi]
version = 1
firmware = ".pio/build/Heltec_v3_repeater_observer_mqtt_sim/firmware-merged.bin"
elf = ".pio/build/Heltec_v3_repeater_observer_mqtt_sim/firmware.elf"