From 51cbab53110fea91a63f5fb77d97d20b07240d6b Mon Sep 17 00:00:00 2001 From: agessaman Date: Mon, 17 Aug 2026 22:19:49 -0700 Subject: [PATCH] feat(rak3401): report onboard SX1262 sleep state via BUSY BUSY is driven low in STDBY_RC and high while asleep, so reading it either side of the sleep gives a non-invasive readback of the state the chip was found in and the state it was left in. Confirmed on hardware. This is what makes the sleep observable at all. The only other symptom of a failed sleep is ~600 uA, which is below what an inline USB meter can resolve, so without this a regression would be silent. It immediately earned itself: busy_before reads 0 on every boot, showing the cold sleep does not survive an MCU reset. GPIOs revert to input during reset, NSS stops being driven high, and the falling edge wakes the chip. The helper re-sleeps it, so this is self-healing, but it means the chip is never found already asleep. --- variants/rak3401/target.cpp | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/variants/rak3401/target.cpp b/variants/rak3401/target.cpp index 640b4d027..dac12ede7 100644 --- a/variants/rak3401/target.cpp +++ b/variants/rak3401/target.cpp @@ -47,12 +47,20 @@ static void sleep_onboard_radio() { Module mod(ONBOARD_LORA_NSS, ONBOARD_LORA_DIO_1, ONBOARD_LORA_RESET, ONBOARD_LORA_BUSY, SPI); SX1262 onboard(&mod); + // BUSY is driven low in STDBY_RC and high while asleep, so it doubles as a + // non-invasive readback of what state we found the chip in and left it in. + pinMode(ONBOARD_LORA_BUSY, INPUT); + int busy_before = digitalRead(ONBOARD_LORA_BUSY); + // begin() resets the chip and leaves it in standby. A TCXO calibration failure // still leaves SPI usable, so issue the sleep regardless of what it returns. int status = onboard.begin(434.0f, 125.0f, 9, 7, RADIOLIB_SX126X_SYNC_WORD_PRIVATE, 0, 8, ONBOARD_LORA_TCXO_VOLTAGE, false); int slept = onboard.sleep(false); // cold sleep: config discarded, RTC off - MESH_DEBUG_PRINTLN("onboard SX1262: begin=%d sleep=%d", status, slept); + delay(2); + int busy_after = digitalRead(ONBOARD_LORA_BUSY); + MESH_DEBUG_PRINTLN("onboard SX1262: begin=%d sleep=%d busy %d->%d", + status, slept, busy_before, busy_after); SPI.end(); // release SPIM3 so std_init() can repin it onto the RAK13302