some older ESP32 boards were pushing the limits of the dram segment causing the linker to fail, especially for ble and wifi firmwares.
lowering OFFLINE_QUEUE_SIZE reduces dram usage
This slipped through in PR #2327 and I noticed because the TechoBoard.h
for my variant doesn't include the Wire header, so the source file
in question does not coincidentally obtain a copy.
The `::init` method in the Adafruit ST7789 library is responsible to
initialize the device. This includes performing a reset, which can be
found in the Adafruit source for `Adafruit_SPITFT`.
Before this change, MeshCore performed its own ST7789 display reset
sequence, which consisted of three steps.
* Pull reset low
* Wait 10ms
* Pull reset high
Importantly, there was no fixed delay after pulling reset high. The
ST7789 driver requires a delay (T<sub>RT</sub>) of 5ms in Sleep In Mode
and 120ms in Sleep Out Mode before it will properly receive commands.
When `Adafruit_SPITFT` resets the device after MeshCore has already
reset it, the mandatory time may not have elapsed, leading to strange
behavior. In the author's case, this issue caused the initial
`fillScreen` to fail, such that the display showed an uninitialized
framebuffer.
This removes the MeshCore delay, leaving the responsibility of reset to
`Adafruit_SPITFT`, where they have the correct delays in place with
extra safety margin. The change was briefly tested by Josiah VanderZee
and Ben Zignego on a custom hardware build using an nRF52840 Dongle and
an Adafruit 4311 TFT display. The user button seemed to behave
strangely, but the display looked correct.
USE_LR1110 was missing from the preprocessor guard in CommonCLI.cpp,
causing both get and set to fail silently on T1000-E:
- get radio.rxgain returned the full radio config string (fell through
to the memcmp("radio", 5) branch)
- set radio.rxgain returned "unknown config" (no branch matched)
Fix: add -D USE_LR1110 to variants/t1000-e/platformio.ini and include
USE_LR1110 in the #if guard on both get and set branches.
CustomLR1110Wrapper already implements setRxBoostedGainMode() and
getRxBoostedGainMode() via the RadioLibWrapper virtual interface,
so no radio-layer changes are required.
Tested on T1000-E: get/set/persist all confirmed working.
Huw Duddy