Add a dimmed heartbeat for the SenseCAP Solar (P1 Pro) white LED in the
repeater firmware, implemented entirely as a SenseCapSolarBoard::loop()
override so no example main.cpp needs to be touched:
- 100 ms pulse every 5 s, dimmed to 10% brightness via hardware PWM
(NRF_PWM0 / HwPWM0, 1 kHz, COUNTERTOP 16000, compare 1600)
- during the 4.9 s off phase the PWM peripheral is stopped (ENABLE=0),
the pin is released (PSEL disconnect) and GPIO 11 is held LOW, so no
HFCLK is demanded between pulses
- on successful application-level "start ota" the PWM is stopped and the
white LED goes steady full-brightness while BLE OTA is advertised;
on failed start the heartbeat keeps blinking
- powerOff() stops/releases the heartbeat PWM before shutting the LED off
- non-blocking millis() timing with wrap-safe unsigned arithmetic
- gated by SENSECAP_SOLAR_WHITE_LED, defined only in the
SenseCap_Solar_repeater PlatformIO env, so the room-server and
companion firmwares sharing this board class are unaffected
No changes to LoRa/repeater forwarding, the blue TX LED, charging LEDs,
GPS, power management, config storage or the bootloader.
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.
The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.
Signed-off-by: Frieder Schrempf <frieder@fris.de>