Boards own their FEM control through handleCommand() ("get/set
radio.fem.rxgain|txgain"). Use that instead of a parallel set of FEM
virtuals on MainBoard, so any board that implements the commands works
in KISS with no extra code.
- Remove the six FEM virtuals from MainBoard and the board overrides.
- KissModem talks to the board in one adapter. A gain counts as
controllable only if "get" replies exactly "> on" or "> off". "set"
is checked by reading the state back, never by its reply wording.
- SetFemState always replies with the read-back state once the
requested bits pass the capability check.
- Guard the boards' prefs writes against a NULL store. KISS attaches
no prefs, so "set radio.fem.*" would dereference NULL.
- Wio Tracker L1 1W TX gain is exposed again, matching its CLI.
The GC1109 FEM needs its VFEM_Ctrl pin held HIGH during deep sleep
to keep the LNA active, enabling proper RX sensitivity for
wake-on-packet. Without this, the LNA is unpowered during sleep
and RX wake sensitivity is degraded by ~17dB.
Release RTC holds in begin() after configuring GPIO registers
(not before) to ensure glitch-free pin transitions on wake.
Trade-off: ~6.5mA additional sleep current for significantly
improved wake-on-packet range.