* room server: added RegionMap, and new CommonCLI wiring, default_scope handling
* sensor: only minimal RegionMap wiring. Still needs work to handle default-scope
ESP-NOW radios (ie, Generic_ESPNOW_* variants) do not compile due to
missing methods
Changes in January 2026 (019bbf74) to add additional stats (receive errors)
to CMD_GET_STATS was not implemented in the ESPNOWRadio() class
Changes in March 2026 (9a95e25e) to add setRxBoostedGainMode to all devices
rather than just SX1262/SX1268 were not applied to the ESPNowRadio() driver
Specifically, this change adds the following to ESPNOWRadio()
* getPacketsRecvErrors() - always returns 0
* getRxBoostedGainMode() - always returns false
* setRxBoostedGainMode() - does nothing
Drive WB_IO2 (slot power switch) HIGH via early constructor before the
Arduino framework initializes. Without this, the board brownouts on
POE-only power because the slot MOSFET isn't enabled early enough for
the RAK13800 POE module to deliver power to the baseboard.
Also remove the W5100S hardware reset pulse from Ethernet init — the
chip comes out of power-on reset cleanly, and toggling reset kills
the PHY link which breaks POE power delivery.
Allow for platformio.ini files to override the default values for the
following INA3221 related macros:
TELEM_INA3221_ADDRESS
TELEM_INA3221_SHUNT_VALUE
TELEM_INA3221_NUM_CHANNELS
Signed-off-by: Paul Moore <paul@paul-moore.com>
Resolve conflicts: keep both Ethernet CLI and SenseCAP power-off
button code in repeater, keep both Ethernet docs and power management
CLI docs.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
The Ethernet retry loop in repeater and room server checked
hardwareStatus() and linkStatus() before calling Ethernet.begin(),
which always returned EthernetNoHardware since hardware detection
only happens during begin(). Extract shared Ethernet CLI code into
EthernetCLI.h to prevent future divergence. Also fix time_t type
mismatch in companion radio Ethernet init.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Rename eth command to eth.status for consistency with other commands
- Rename generateDeviceMac to generateEthernetMac for clarity
- Refactor ethernet_handle_command to return false by default
- Allow new TCP clients to replace existing connections (repeater, room server, SerialEthernetInterface)
- Boot companion radio without Ethernet on init failure (LoRa-only recovery mode)
- Remove > prompt from ethernet CLI for consistency with serial interface
- Fix variable redeclaration compile error in SerialEthernetInterface when ETHERNET_STATIC_IP is defined
- Fix TCP socket leak when duplicate client detection fires
- Remove dead recv_queue and adv_restart_time members from SerialEthernetInterface
- Fix port numbers in docs (port 23 for repeater/room server CLI, port 5000 for companion radio)
- Clarify eth.status command is only available in repeater and room server firmware
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Ryan Gregg