Drop BLE_TX_POWER=0 from the companion envs so they use the default of
4 dBm, like most other variants. The lower power was carried over from
the original Base Duo PR and real-world range is better at the default.
- rename the board class and files to MuziBaseBoard
- uppercase the build flags (MUZI_BASE, MUZI_BASE_SUPERIO)
- name the superIO envs muzi_base_{duo,uno}_superIO_companion_radio_ble so
build.sh picks them up
- set MAX_CONTACTS to 350 like the other variants
- move the pin setup from initVariant() into MuziBaseBoard::begin()
One nRF52840 variant shared across both radios, picked per env: Duo runs
the LR1121, Uno the SX1262. Same PCB, only the radio and its DIO1 pin
change.
SuperIO adds the SH1107 OLED, GPS, buzzer and joystick. GPS is driven by
the 3-position mode switch (Mode 2 = on), polled live the way thinknode_m1
does it.
Five quick user-button presses power the unit off; a press wakes it back
on (arms the button as an nRF52 GPIO SENSE source before SYSTEMOFF).
Consolidates #2054 and andyshinn's shared-base/uno work, rebased on dev.
Co-authored-by: lbibass <ewdries02@gmail.com>
Co-authored-by: Andy Shinn <andys@andyshinn.as>
SerialWifiInterface has no ESP32-specific code, so move it to
helpers/wifi and reuse it on RP2040. Guard the ESP32-only WiFi
event/auto-reconnect calls and poll link state on RP2040 instead.
* Add tz_offset companion prefs and get/set commands for companion cli
* Use tz_offset for clock on display
Signed-off-by: Aleksei Mamlin <mamlinav@gmail.com>
thinknode_m8: initial support
adds some functionalities to ui_task and epddisplay:
epd display,
- supports screen off, and clear screen
- supports forcing full refresh every N partial refreshes (off by default, configured to 60 for M8)
ui_task
- UI_SHOW_CLOCK flag to display clock on first screen
- rotary button can act like joystick (with regards to Enter key), defaults to old config for existing nodes
- screen off on long press when using rotary button (very handy for the watch)
SPI pins that are set to -1 cause OOB reads on NRF52. The unused Serial2 pin definitions were removed to avoid potential issues with the Uart framework.
Setting SPI pins to values that are OOB of the g_ADigitalPinMap[] array causes OOB reads. This variant.h has pin 0 as 0xFF which passes through as NRFX_SPIM_PIN_NOT_USED.
Wessel Nieboer