Add a dimmed heartbeat for the SenseCAP Solar (P1 Pro) white LED in the
repeater firmware, implemented entirely as a SenseCapSolarBoard::loop()
override so no example main.cpp needs to be touched:
- 100 ms pulse every 5 s, dimmed to 10% brightness via hardware PWM
(NRF_PWM0 / HwPWM0, 1 kHz, COUNTERTOP 16000, compare 1600)
- during the 4.9 s off phase the PWM peripheral is stopped (ENABLE=0),
the pin is released (PSEL disconnect) and GPIO 11 is held LOW, so no
HFCLK is demanded between pulses
- on successful application-level "start ota" the PWM is stopped and the
white LED goes steady full-brightness while BLE OTA is advertised;
on failed start the heartbeat keeps blinking
- powerOff() stops/releases the heartbeat PWM before shutting the LED off
- non-blocking millis() timing with wrap-safe unsigned arithmetic
- gated by SENSECAP_SOLAR_WHITE_LED, defined only in the
SenseCap_Solar_repeater PlatformIO env, so the room-server and
companion firmwares sharing this board class are unaffected
No changes to LoRa/repeater forwarding, the blue TX LED, charging LEDs,
GPS, power management, config storage or the bootloader.
ESP32-S3FH4R2 (4MB flash, 2MB PSRAM, native USB-CDC) with an LR1121.
Pins, the DIO5/DIO6 RF switch table and the 1.8 V TCXO follow the HF
schematic and Waveshare's examples. Envs: repeater, room server,
companion USB/BLE and KISS modem, all on min_spiffs so roles share one
partition layout.
Only RFO_HP_LF is wired (R4 on RFO_LP_LF is not fitted), so the new
opt-in LR1121_FORCE_HP_PA flag keeps RadioLib on the HP PA at <= 14 dBm,
where it would otherwise select the unconnected LP PA.
Drop BLE_TX_POWER=0 from the companion envs so they use the default of
4 dBm, like most other variants. The lower power was carried over from
the original Base Duo PR and real-world range is better at the default.
- rename the board class and files to MuziBaseBoard
- uppercase the build flags (MUZI_BASE, MUZI_BASE_SUPERIO)
- name the superIO envs muzi_base_{duo,uno}_superIO_companion_radio_ble so
build.sh picks them up
- set MAX_CONTACTS to 350 like the other variants
- move the pin setup from initVariant() into MuziBaseBoard::begin()