Commit Graph
3 Commits
Author SHA1 Message Date
agessaman 720f0f1528 kiss_modem: reach FEM gain through the board's radio.fem CLI commands
Boards own their FEM control through handleCommand() ("get/set
radio.fem.rxgain|txgain"). Use that instead of a parallel set of FEM
virtuals on MainBoard, so any board that implements the commands works
in KISS with no extra code.

- Remove the six FEM virtuals from MainBoard and the board overrides.
- KissModem talks to the board in one adapter. A gain counts as
  controllable only if "get" replies exactly "> on" or "> off". "set"
  is checked by reading the state back, never by its reply wording.
- SetFemState always replies with the read-back state once the
  requested bits pass the capability check.
- Guard the boards' prefs writes against a NULL store. KISS attaches
  no prefs, so "set radio.fem.*" would dereference NULL.
- Wio Tracker L1 1W TX gain is exposed again, matching its CLI.
2026-09-23 17:31:20 -07:00
agessaman 5527a26f9a kiss_modem: add AGC reset interval and FEM gain control (protocol v2)
Add SetHardware sub-commands so a host can probe and configure
per-board RF front-end settings:

- GetCapabilities (0x1B): uint32 feature bits (AGC, FEM RX, FEM TX)
- Set/GetAgcResetInterval (0x1C/0x1D): 0-1020 s, 4 s resolution,
  0 disables; default stays 30 s
- Set/GetFemState (0x1E/0x1F): apply/value masks for FEM RX (LNA)
  and TX (PA) gain; all-or-nothing, Unsupported (0x08) if any
  requested bit is not controllable on this board

The AGC scheduler moves from main.cpp into KissModem so it is
configurable and unit-tested. FEM changes that arrive mid-TX are
deferred until the packet ends, since board setters drive FEM pins
directly.

MainBoard gains virtual FEM hooks (canControl/set/is for LNA and PA
gain). Boards that already implemented these methods privately now
expose them as overrides: Heltec V4, V4 R8, T096, Tracker V2,
Station G3 and Wio Tracker L1 1W.

KISS_FIRMWARE_VERSION bumped to 2.
2026-09-23 15:43:01 -07:00
ViezeVingertjes fb2c61f862 fix: prevent ESP32 KISS modem stalls under USB backpressure
Switch ESP32-S3 KISS modem environments to HWCDC and move outbound KISS writes to a non-blocking queued frame path so loop() and TX completion keep progressing when the host reads slowly. Add native backpressure regression tests and correct the native_kiss_modem test filter so this suite runs directly with pio test.
2026-07-18 22:43:55 +02:00