Commit Graph
8 Commits
Author SHA1 Message Date
zxw f9c54a1499 feat: Add low-power white status LED for SenseCAP Solar P1 Pro
Add a dimmed heartbeat for the SenseCAP Solar (P1 Pro) white LED in the
repeater firmware, implemented entirely as a SenseCapSolarBoard::loop()
override so no example main.cpp needs to be touched:

- 100 ms pulse every 5 s, dimmed to 10% brightness via hardware PWM
  (NRF_PWM0 / HwPWM0, 1 kHz, COUNTERTOP 16000, compare 1600)
- during the 4.9 s off phase the PWM peripheral is stopped (ENABLE=0),
  the pin is released (PSEL disconnect) and GPIO 11 is held LOW, so no
  HFCLK is demanded between pulses
- on successful application-level "start ota" the PWM is stopped and the
  white LED goes steady full-brightness while BLE OTA is advertised;
  on failed start the heartbeat keeps blinking
- powerOff() stops/releases the heartbeat PWM before shutting the LED off
- non-blocking millis() timing with wrap-safe unsigned arithmetic
- gated by SENSECAP_SOLAR_WHITE_LED, defined only in the
  SenseCap_Solar_repeater PlatformIO env, so the room-server and
  companion firmwares sharing this board class are unaffected

No changes to LoRa/repeater forwarding, the blue TX LED, charging LEDs,
GPS, power management, config storage or the bootloader.
2026-10-30 10:01:52 +08:00
Confi 835b0e9114 fix(sensecap_solar): init LED_WHITE LOW to prevent always-on at boot 2026-04-25 09:47:44 +02:00
Sybren A. Stüvel 9349e6ab6b SenseCap Solar: fix use of LED_GREEN
5188221584 changed LED_RED/GREEN to
LED_WHITE/BLUE, but didn't convert all uses of LED_GREEN.
2026-03-14 21:52:08 +01:00
Specter242 e323755990 sensecap solar: add poweroff command and board power/LED parity 2026-02-27 22:12:12 -05:00
Frieder Schrempf b024b9e1a1 Deduplicate NRF52 startOTAUpdate()
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.

The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.

Signed-off-by: Frieder Schrempf <frieder@fris.de>
2025-12-17 10:30:50 +01:00
Frieder Schrempf 93d1560d14 Use common NRF52 begin() and deduplicate() startup reason init
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.

Signed-off-by: Frieder Schrempf <frieder@fris.de>
2025-12-17 10:26:57 +01:00
recrof e47755c8e9 Seeed SenseCap Solar: invert leds 2025-07-06 15:22:51 +02:00
recrof 2941388041 initial support for Seeed Studio SenseCap Solar board 2025-07-04 15:03:25 +02:00