#include #include "target.h" #include NucleoWL55JCBoard board; RADIO_CLASS radio = new STM32WLx_Module(); WRAPPER_CLASS radio_driver(radio, board); // The NUCLEO-WL55JC1 drives an SP3T front-end switch from FE_CTRL1..3 (PC4, PC5, PC3), // routing the single SMA between RX, RFO_LP and RFO_HP. Pin order and levels are taken // straight from the core's board definition (variant_NUCLEO_WL55JC1.h) so they stay in // sync with upstream. static const uint32_t rfswitch_pins[] = {LORAWAN_RFSWITCH_PINS, RADIOLIB_NC, RADIOLIB_NC}; static const Module::RfSwitchMode_t rfswitch_table[] = { {STM32WLx::MODE_IDLE, {LORAWAN_RFSWITCH_OFF_VALUES}}, {STM32WLx::MODE_RX, {LORAWAN_RFSWITCH_RX_VALUES}}, {STM32WLx::MODE_TX_LP, {LORAWAN_RFSWITCH_RFO_LP_VALUES}}, {STM32WLx::MODE_TX_HP, {LORAWAN_RFSWITCH_RFO_HP_VALUES}}, END_OF_MODE_TABLE, }; VolatileRTCClock rtc_clock; SensorManager sensors; #ifndef LORA_CR #define LORA_CR 5 #endif #ifndef STM32WL_TCXO_VOLTAGE // The board is fitted with a 32MHz TCXO powered from the radio's DIO3 at 1.7V #define STM32WL_TCXO_VOLTAGE 1.7 #endif #ifndef LORA_TX_POWER #define LORA_TX_POWER 22 #endif bool radio_init() { radio.setRfSwitchTable(rfswitch_pins, rfswitch_table); // Both PA paths are registered above, so RadioLib picks RFO_HP whenever the // requested power is above 14dBm, and RFO_LP below that. int status = radio.begin(LORA_FREQ, LORA_BW, LORA_SF, LORA_CR, RADIOLIB_SX126X_SYNC_WORD_PRIVATE, LORA_TX_POWER, 16, STM32WL_TCXO_VOLTAGE, 0); if (status != RADIOLIB_ERR_NONE) { Serial.print("ERROR: radio init failed: "); Serial.println(status); return false; // fail } #ifdef RX_BOOSTED_GAIN radio.setRxBoostedGainMode(RX_BOOSTED_GAIN); #endif radio.setCRC(1); return true; // success } mesh::LocalIdentity radio_new_identity() { RadioNoiseListener rng(radio); return mesh::LocalIdentity(&rng); // create new random identity }