mirror of
https://github.com/meshcore-dev/MeshCore.git
synced 2026-11-22 07:37:08 +00:00
Adds repeater, room_server, companion_radio_usb and kiss_modem environments for the NUCLEO-WL55JC1 (STM32WL55JC, integrated SubGHz radio). Notes on the board setup: - Uses the upstream nucleo_wl55jc board. PlatformIO's boards_remap maps it to the core's NUCLEO_WL55JC1 variant, so the LEDs, user buttons and the LPUART1 -> ST-LINK VCP serial mapping all come from the core rather than being redefined here. - The RF switch table is built from the core's LORAWAN_RFSWITCH_* macros (SP3T front end on PC3/PC4/PC5) so it tracks upstream if those are ever revised. Both RFO_LP and RFO_HP are registered, so RadioLib selects HP above 14 dBm and LP below it. - board_build.extra_flags pins the device to STM32WL55xx. The stock board manifest declares product_line STM32WL55xx but extra_flags -DSTM32WLE5xx; that only works because every #elif chain happens to test WL55xx first. - The Nucleo's LD1..LD3 are driven active HIGH, so the TX LED hooks are inverted relative to STM32Board's active-LOW default. - 32 KB reserved at the top of flash for LittleFS, as on the other STM32WL variants. Verified on hardware: all four environments build; repeater and room_server flash and run over ST-LINK; identity and prefs persist across reboot and across a firmware swap; and GPIOC reads back the documented RX levels at idle, confirming the front-end switch is driven correctly. Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>