Files
MeshCore/variants/heltec_tracker_v2/HeltecTrackerV2Board.h
T
agessaman 720f0f1528 kiss_modem: reach FEM gain through the board's radio.fem CLI commands
Boards own their FEM control through handleCommand() ("get/set
radio.fem.rxgain|txgain"). Use that instead of a parallel set of FEM
virtuals on MainBoard, so any board that implements the commands works
in KISS with no extra code.

- Remove the six FEM virtuals from MainBoard and the board overrides.
- KissModem talks to the board in one adapter. A gain counts as
  controllable only if "get" replies exactly "> on" or "> off". "set"
  is checked by reading the state back, never by its reply wording.
- SetFemState always replies with the read-back state once the
  requested bits pass the capability check.
- Guard the boards' prefs writes against a NULL store. KISS attaches
  no prefs, so "set radio.fem.*" would dereference NULL.
- Wio Tracker L1 1W TX gain is exposed again, matching its CLI.
2026-09-23 17:31:20 -07:00

31 lines
818 B
C++

#pragma once
#include <Arduino.h>
#include <helpers/RefCountedDigitalPin.h>
#include <helpers/ESP32Board.h>
#include "LoRaFEMControl.h"
class HeltecTrackerV2Board : public ESP32Board {
KeyValueStore* _prefs = NULL;
bool setLoRaFemLnaEnabled(bool enable);
bool isLoRaFemLnaEnabled() const;
public:
RefCountedDigitalPin periph_power;
LoRaFEMControl loRaFEMControl;
HeltecTrackerV2Board() : periph_power(PIN_VEXT_EN,PIN_VEXT_EN_ACTIVE) { }
void begin();
void attachDynamicPrefs(KeyValueStore* prefs);
bool handleCommand(const char* command, uint32_t sender_timestamp, char* reply) override;
void onBeforeTransmit(void) override;
void onAfterTransmit(void) override;
void powerOff() override;
uint16_t getBattMilliVolts() override;
const char* getManufacturerName() const override ;
};