main_repeater.cpp and main_room_server.cpp applied the GPS duty interval
~55 lines before data_store.loadPrefs() ran, so getNodePrefs()->gps_interval
still held the initNodePrefs() value of 300 s.
That 300 is the *companion* default. loadPrefs() is not a pure read on these
roles: its first-boot path is the only place the 48 h repeater/room-server
default is established, and it persists that to flash so later code can treat
flash as authoritative. A stored value is likewise only in the struct after
loadPrefs() returns. Reading gps_interval before that call therefore cannot
see either the role default or the operator's setting -- only the companion
constant.
Two consequences, on every boot:
- A stock GPS-equipped repeater duty-cycled its GPS every 5 minutes instead
of every 48 hours, ~576x more wakeups than intended. On battery nodes this
is a straight power regression.
- Any operator value never reached the hardware. "set gps duty 0" (always-on)
persisted to flash correctly, and `get gps duty` reports the manager's
now-effective value, so it answered 300 -- readable as a stale default
rather than as the setting being ignored.
The GPS manager itself is correct: gps_start_acquiring(), the fix-done
callback, gps_enable() and the fresh-fix request all guard standby on
gps_duty_cycling(), so the always-on invariant holds once the manager is
actually told the interval is zero.
Same ordering class as the two bugs already documented in these files -- radio
frequency binding and the LED master switch -- where CLI readback looked right
and the hardware disagreed. main_companion.cpp has always had the correct
order (loadPrefs() at 1461, gps_set_poll_interval_sec() at 1616) and is
unaffected.
Move the interval and the mode switch that starts acquisition to just after
loadPrefs(). Callback registration stays where it was: it has no prefs
dependency and must precede acquisition.
Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>
Both emit ENTER via a zephyr,input-longpress filter (single button),
same category the Kconfig help text already documents as needing
CONFIG_ZEPHCORE_UI_CONFIRM_WINDOW_MS=3000 instead of the 500ms
default -- two ~1s holds don't fit in 500ms, so the second long press
on shutdown/DFU/offgrid always arrives after the window closed and
just re-arms instead of confirming. T096 already had this set
(board.conf:38); WT2 and V4.3 didn't, apparently missed when their
board.conf was written.
liquidraver