data.
Without the check, it was getting tripped by publisher not publishing
any data. Both conditions returned nil, but in one case, the receiver
report should have been received, but no movement in number of packets.
* Run quality scorer when there are no streams.
In the down stream direction, receiver report is used for scoring.
If there are no receiver reports, it should go to `dry` state and report
poor quality.
Update scorer on dry condition only when update score has not happened
for longer than some multiple of update interval. Cannot update on every
interval when there are no streams as receiver report might be just
missed. Waiting for longer to ensure that report is definitely not
received.
* update last stats time
When current became unavailable, it was possible for
target to be set to opportunistic. Because of that,
the downgrade did not happen and PLI layer lock was
requested continuously.
* A coupke of stream allocator tweaks
- Do not overshoot on catch up. It so happens that during probe
the next higher layer is at some bit rate which is much lower
than normal bit rate for that layer. But, by the time the probe
ends, publisher has climbed up to normal bit rate.
So, the probe goal although achieved is not enough.
Allowing overshoot latches on the next layer which might be more
than the channel capacity.
- Use a collapse window to record values in case of a only one
or two changes in an evaluation window. Some times it happens
that the estimate falls once or twice and stays there. By collapsing
repeated values, it could be a long time before that fall in estimate
is processed. Introduce a collapse window and record duplicate value
if a value was not recorded for collapse window duration. This allows
delayed processing of those isolated falls in estimate.
* minor clean up
* add a probe max rate
* fix max
* use max of committed, expected for max limiting
* have to probe at goal
When detecting congestion based on loss, it is possible that
the loss based signal triggers earlier and the estimate based
signal is lagging. In those cases, check against last received
estimate and if that is lower than loss based throttling, use that.
Without this, it was possible that the current usage high.
Loss based throttling may not dial things back far enough to pause
the stream. Ideally, congestion should hit again and it should be dialled
down further and eventually pause, but there are situations it never
dials back far enough to pause.
* Do not let request layer overshoot available.
After a layer stopped on publisher side, an optimal allocation side
while initially adjusted to not request the stopped layer, a subsequent
allocation went back to the higher layer although it was stopped.
Prevent that.
* simplify
* Support simualting subscriber bandwidth.
When non-zero, a full allocation is triggered.
Also, probes are stopped.
When set to zero, normal probing mechanism should catch up.
Adding `allowPause` override which can be a connection option.
* fix log
* allowPause in participant params
* Decode chains
* clean up
* clean up
* decode targets only on publisher side
* comment out supported codecs
* fix test compile
* fix another test compile
* Adding TODO notes
* chainID -> chainIdx
* do not need to check for switch up point when using chains, as long as chain integrity is good, can switch
* more comments
* address comments
Raja Subramanian