Show a small lightning-bolt icon to the left of the battery indicator on
the ui-new home screen while the device is externally powered, and a plug
icon once the battery reads full. The bolt/plug sits beside the battery so
the fill bar stays clean and uninterrupted. When a buzzer is present, the
mute icon shifts one slot further left so the two never overlap.
Charging state is derived from board.isExternalPowered(), so this works on
any board that reports external power (e.g. the nRF52 VBUS-detect path).
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
thinknode_m8: initial support
adds some functionalities to ui_task and epddisplay:
epd display,
- supports screen off, and clear screen
- supports forcing full refresh every N partial refreshes (off by default, configured to 60 for M8)
ui_task
- UI_SHOW_CLOCK flag to display clock on first screen
- rotary button can act like joystick (with regards to Enter key), defaults to old config for existing nodes
- screen off on long press when using rotary button (very handy for the watch)
RadioLibWrapper::setTxPower() called setOutputPower() and nothing else. On
LR2021 that writes the PA config and TxParams, which are standby-only commands,
and it never re-arms the receiver.
This only affects LR2021 boards. recvRaw() has:
#if defined(USE_LR2021)
state = STATE_RX; // LR2021 stays in Rx after readData
#else
state = STATE_IDLE; // need another startReceive()
#endif
so on SX126x the next recvRaw() re-arms Rx anyway and the write is harmless,
while on LR2021 startReceive() is never called again on its own. A 'set tx'
issued while the radio was listening could therefore stop reception until the
next reboot. Observed a few times on an LR2021 repeater; recovery required a
power cycle.
Dispatcher's stuck-radio check does not catch it: isInRecvMode() reports the
wrapper's own `state` flag rather than the chip's actual mode, so it still
believes the radio is in Rx, and it only raises ERR_EVENT_STARTRX_TIMEOUT
without attempting recovery.
Fix: on LR2021, drop to standby via idle() before writing the PA config and let
checkRecv() re-arm Rx - the same pattern resetAGC() and
applySideDetectorConfig() already use. Other radios are left untouched.
Affects meshtracker_x1 and meshnology_w12 (both USE_LR2021).
Tested on hardware with an LR2021 repeater: six consecutive 'set tx' changes
(15/18/21/14/19/14), after which the radio kept receiving and forwarding
traffic (rawrx/rxpkts increasing, no missed IRQs). Noise-floor sampling also
kept updating, which only happens while state == STATE_RX.
SPI pins that are set to -1 cause OOB reads on NRF52. The unused Serial2 pin definitions were removed to avoid potential issues with the Uart framework.
Setting SPI pins to values that are OOB of the g_ADigitalPinMap[] array causes OOB reads. This variant.h has pin 0 as 0xFF which passes through as NRFX_SPIM_PIN_NOT_USED.
Introduced consistent preferences for external LoRa FEM RX and TX gain settings in NodePrefs. Updated companion MyMesh to apply these settings during initialization and transmission. Added unit tests to verify the round-trip serialization of these new preferences.
