The Waveshare RP2040-LoRa board has an RF switch with two complementary
control lines:
- DIO2 (CTRL) -- driven automatically by the SX1262 chip: HIGH on TX,
LOW on RX
- GPIO17 (!CTRL) -- was not configured in MeshCore, so it floated and
the switch never properly selected the LNA/RX path
Without this pin driven, the RF switch never switches to RX mode,
resulting in completely degraded reception. TX was unaffected because
DIO2 alone is sufficient to activate the TX path.
Adding SX126X_RXEN=17 lets RadioLib drive GPIO17 as the complement of
DIO2, so the switch correctly routes the signal to the LNA on receive.
Reference: https://files.waveshare.com/wiki/RP2040-LoRa/Rp2040-lora-sch.pdf
variants/thinknode_m5/platformio.ini contained actual WiFi SSID and
password credentials (Livebox-633C) committed by mistake. Replaced
with placeholder values consistent with other variants (myssid/mypwd).
env:Generic_ESPNOW_room_svr was using 'Heltec Room' as ADVERT_NAME,
causing Generic ESPNow room server nodes to advertise with the wrong
device name on the mesh.
Repeater and Room Server environments in variants/thinknode_m5/platformio.ini
were using 'Thinknode M2' as the ADVERT_NAME, causing M5 nodes to advertise
with the wrong device name on the mesh.
- env:ThinkNode_M5_Repeater: 'Thinknode M2 Repeater' -> 'Thinknode M5 Repeater'
- env:ThinkNode_M5_room_server: 'Thinknode M2 Room Server' -> 'Thinknode M5 Room Server'
ESP-NOW radios (ie, Generic_ESPNOW_* variants) do not compile due to
missing methods
Changes in January 2026 (019bbf74) to add additional stats (receive errors)
to CMD_GET_STATS was not implemented in the ESPNOWRadio() class
Changes in March 2026 (9a95e25e) to add setRxBoostedGainMode to all devices
rather than just SX1262/SX1268 were not applied to the ESPNowRadio() driver
Specifically, this change adds the following to ESPNOWRadio()
* getPacketsRecvErrors() - always returns 0
* getRxBoostedGainMode() - always returns false
* setRxBoostedGainMode() - does nothing
The companion_radio example was not restoring the GPS enabled/disabled
preference from flash after reboot. The preference was being saved
correctly when toggled via the mobile app, but on boot,
sensors.begin() -> initBasicGPS() unconditionally sets gps_active=false
and nothing subsequently restored the persisted state.
Added applyGpsPrefs() (matching the pattern in simple_repeater,
simple_sensor, and simple_room_server) and call it from main.cpp
after sensors.begin() to ensure the GPS hardware is initialized
before the saved preference is applied.
Petr Kracik