Unless your GPS is being spoofed there isn't really a downside to
syncing more often with GPS.
I understand the RTC is very stable, but especially with powersaving now
clock drift is worse, we should sync more often.
- Change > to >= so stored value 1 means direct/0-hop only (liamcottle)
- Clamp max_hops to 63 on write since getPathHashCount() caps at 63 (robekl)
- Update comments to reflect encoding: 0=no limit, 1=direct only, N=up to N-1 hops
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Filter auto-add of new contacts by hop count (issues #1533, #1546).
Setting is configurable from the companion app via extended
CMD_SET/GET_AUTOADD_CONFIG protocol (0 = no limit, 1-63 = max hops).
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
On the T114, GPS_RESET (pin 38) is the same pin as PIN_3V3_EN.
MicroNMEALocationProvider::begin() sets pin 38 HIGH (powering the 3V3
rail) but stop() never set it back LOW, leaving the GPS module powered
even when disabled.
Assert reset pin in stop() to mirror begin(), and guard
_location->loop() behind gps_active check.
Fixesmeshcore-dev/MeshCore#1628
1. warm sleep
2. wake to stdby
3. Calibrate(0x7F) to reset all internal blocks
4. re-apply DIO2 RF / boosted gain & register patch to make sure
everything is as it was
PacketQueue::countBefore() and PacketQueue::get() use unsigned
comparison (_schedule_table[j] > now) to check if a packet is
scheduled for the future. This breaks when millis() wraps around
after ~49.7 days: packets scheduled just before the wrap appear
to be in the far future and get stuck in the queue.
Use signed subtraction instead, matching the approach already used
by Dispatcher::millisHasNowPassed(). This correctly handles the
wraparound for time differences up to ~24.8 days in either
direction, well beyond the maximum queue delay of 32 seconds.
PacketQueue::add() silently dropped packets when the queue was at
capacity. The packet pointer was lost — never enqueued, never returned
to the unused pool. Each occurrence permanently shrank the 32-packet
pool until allocNew() returned NULL and the node went deaf. Return bool
from add() and free the packet back to the pool on failure.
Liam Cottle