Boards own their FEM control through handleCommand() ("get/set
radio.fem.rxgain|txgain"). Use that instead of a parallel set of FEM
virtuals on MainBoard, so any board that implements the commands works
in KISS with no extra code.
- Remove the six FEM virtuals from MainBoard and the board overrides.
- KissModem talks to the board in one adapter. A gain counts as
controllable only if "get" replies exactly "> on" or "> off". "set"
is checked by reading the state back, never by its reply wording.
- SetFemState always replies with the read-back state once the
requested bits pass the capability check.
- Guard the boards' prefs writes against a NULL store. KISS attaches
no prefs, so "set radio.fem.*" would dereference NULL.
- Wio Tracker L1 1W TX gain is exposed again, matching its CLI.
Add SetHardware sub-commands so a host can probe and configure
per-board RF front-end settings:
- GetCapabilities (0x1B): uint32 feature bits (AGC, FEM RX, FEM TX)
- Set/GetAgcResetInterval (0x1C/0x1D): 0-1020 s, 4 s resolution,
0 disables; default stays 30 s
- Set/GetFemState (0x1E/0x1F): apply/value masks for FEM RX (LNA)
and TX (PA) gain; all-or-nothing, Unsupported (0x08) if any
requested bit is not controllable on this board
The AGC scheduler moves from main.cpp into KissModem so it is
configurable and unit-tested. FEM changes that arrive mid-TX are
deferred until the packet ends, since board setters drive FEM pins
directly.
MainBoard gains virtual FEM hooks (canControl/set/is for LNA and PA
gain). Boards that already implemented these methods privately now
expose them as overrides: Heltec V4, V4 R8, T096, Tracker V2,
Station G3 and Wio Tracker L1 1W.
KISS_FIRMWARE_VERSION bumped to 2.
Enable GPS time synchronization across all variants by passing
&rtc_clock to MicroNMEALocationProvider. When GPS gets a valid
fix, the RTC clock is now updated automatically every 30 minutes.
Updated 16 variants: rak4631, lilygo_tbeam_SX1262, rak_wismesh_tag,
lilygo_tbeam_supreme_SX1262, thinknode_m3, heltec_v4, thinknode_m1,
lilygo_tbeam_SX1276, meshadventurer, nano_g2_ultra, heltec_v3,
promicro, xiao_c3, heltec_tracker_v2, keepteen_lt1, heltec_mesh_solar.
The GC1109 FEM needs its VFEM_Ctrl pin held HIGH during deep sleep
to keep the LNA active, enabling proper RX sensitivity for
wake-on-packet. Without this, the LNA is unpowered during sleep
and RX wake sensitivity is degraded by ~17dB.
Release RTC holds in begin() after configuring GPIO registers
(not before) to ensure glitch-free pin transitions on wake.
Trade-off: ~6.5mA additional sleep current for significantly
improved wake-on-packet range.