PA PL1 re-targets the PA's DC-DC supply rail rather than selecting a
logic-level gain, and the serial CLI is serviced on every main-loop pass
regardless of whether a transmit is in flight. A `set radio.fem.txgain`
write could therefore move the rail mid-transmit, while the SX1262 was
still driving the PA at full input power.
Record the requested level in setPAGainEnable() and drive the pin from
setTxModeEnable(), which runs from onBeforeTransmit() ahead of
startTransmit(). The level only matters while transmitting, so deferring
costs nothing.
Document that the pref is saved immediately but applied at the next
transmit, so `get radio.fem.txgain` can lead the hardware until then.
mkdocs will only consider the first H1 (if any) and subheaders under it for the table of contents
this increases the header levels of everything below "important concepts" by 1 so that the table of contents correctly resolves them
Switch ESP32-S3 KISS modem environments to HWCDC and move outbound KISS writes to a non-blocking queued frame path so loop() and TX completion keep progressing when the host reads slowly. Add native backpressure regression tests and correct the native_kiss_modem test filter so this suite runs directly with pio test.
Adds a small allocation for groupdata packets for the Meshcore firmware for the StreamSensor product. It was previously a LoRaWAN platform, and we've moved to Meshcore.
Let me know when and how to demonstrate.
Adds a small allocation for groupdata packets for the Meshcore firmware for the StreamSensor product. It was previously a LoRaWAN platform, and we've moved to Meshcore.
Extract the inline cursor-walk in handleRegionCmd into file-local
helpers (skipSpaces, rtrimSpaces, takeToken, splitNameJump,
processRegionDefSegment), grouped immediately above the consumer.
Behavior is identical; addresses PR #2540 review feedback on
readability.
Tighten the region def docs: collapse five Note callouts into three
grouped paragraphs (Behavior / Existing regions / Limits), add a
case-sensitivity caveat plus an error example, note the cursor reset
between split commands, and use generic placeholder names.
Adam Gessaman