Files
MeshCore/variants
Will MacGregorandClaude Opus 5 dd78cc35d2 Add variant for ST Nucleo-WL55JC1
Adds repeater, room_server, companion_radio_usb and kiss_modem
environments for the NUCLEO-WL55JC1 (STM32WL55JC, integrated SubGHz radio).

Notes on the board setup:

- Uses the upstream nucleo_wl55jc board. PlatformIO's boards_remap maps it
  to the core's NUCLEO_WL55JC1 variant, so the LEDs, user buttons and the
  LPUART1 -> ST-LINK VCP serial mapping all come from the core rather than
  being redefined here.
- The RF switch table is built from the core's LORAWAN_RFSWITCH_* macros
  (SP3T front end on PC3/PC4/PC5) so it tracks upstream if those are ever
  revised. Both RFO_LP and RFO_HP are registered, so RadioLib selects HP
  above 14 dBm and LP below it.
- board_build.extra_flags pins the device to STM32WL55xx. The stock board
  manifest declares product_line STM32WL55xx but extra_flags -DSTM32WLE5xx;
  that only works because every #elif chain happens to test WL55xx first.
- The Nucleo's LD1..LD3 are driven active HIGH, so the TX LED hooks are
  inverted relative to STM32Board's active-LOW default.
- 32 KB reserved at the top of flash for LittleFS, as on the other
  STM32WL variants.

Verified on hardware: all four environments build; repeater and room_server
flash and run over ST-LINK; identity and prefs persist across reboot and
across a firmware swap; and GPIOC reads back the documented RX levels at
idle, confirming the front-end switch is driven correctly.

Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>
2026-11-04 09:46:40 -05:00
..
2026-09-23 15:04:51 +12:00
2026-09-15 22:59:09 +02:00
2026-09-15 22:59:09 +02:00
2026-09-15 22:59:09 +02:00
2026-07-06 12:04:42 -04:00
2026-08-18 19:40:42 +02:00
2026-09-15 22:59:09 +02:00