Files
MeshCore/variants/sensecap_solar
zxw f9c54a1499 feat: Add low-power white status LED for SenseCAP Solar P1 Pro
Add a dimmed heartbeat for the SenseCAP Solar (P1 Pro) white LED in the
repeater firmware, implemented entirely as a SenseCapSolarBoard::loop()
override so no example main.cpp needs to be touched:

- 100 ms pulse every 5 s, dimmed to 10% brightness via hardware PWM
  (NRF_PWM0 / HwPWM0, 1 kHz, COUNTERTOP 16000, compare 1600)
- during the 4.9 s off phase the PWM peripheral is stopped (ENABLE=0),
  the pin is released (PSEL disconnect) and GPIO 11 is held LOW, so no
  HFCLK is demanded between pulses
- on successful application-level "start ota" the PWM is stopped and the
  white LED goes steady full-brightness while BLE OTA is advertised;
  on failed start the heartbeat keeps blinking
- powerOff() stops/releases the heartbeat PWM before shutting the LED off
- non-blocking millis() timing with wrap-safe unsigned arithmetic
- gated by SENSECAP_SOLAR_WHITE_LED, defined only in the
  SenseCap_Solar_repeater PlatformIO env, so the room-server and
  companion firmwares sharing this board class are unaffected

No changes to LoRa/repeater forwarding, the blue TX LED, charging LEDs,
GPS, power management, config storage or the bootloader.
2026-10-30 10:01:52 +08:00
..
2026-03-12 18:14:56 +11:00