Files
MeshCore/variants/rak4631
Martin Boissonneault 666949fae4 rak4631: let the serial GPS switch the WB_IO2 rail (opt-in)
On a RAK19007 the RAK12501's supply is 3V3_S, switched by WB_IO2, so
gps off, periodic mode and shutdown left it powered. Pass WB_IO2 to the
NMEA driver as peripheralPower under GPS_RAIL_POWER_CONTROL, set by the
new RAK_4631_repeater_gps_power env. It is opt-in because the rail feeds
every slot module, and refused with ETHERNET_ENABLED (RAK13800).

The RAK12500 (I2C) driver keeps switching its own power pin, so this
only applies on the NMEA path.

RefCountedDigitalPin now sets OUTPUT on claim and release: WB_IO2 left
as an input (as probeRak12500() leaves it after a failed probe) keeps
3V3_S in its last state, so writing the latch alone did not cut it.

Measured with a KM003C, battery and panel out: gps off 40.5 -> 12.4 mA,
shutdown 29.7 -> 1.30 mA.
2026-11-08 08:47:35 -04:00
..