* Add option to issue full reconnect on data channel error.
There are situations where send data packet fails because of "stream
closed". It is unclear when that happens. Seems to be after an
ICERestart after ICE failed and connection type switching to TURN
from ICE.
Once the failure happens, it is not recoverable. Potentially, it is
recoverable, but unclear where the problem lies. Attempts to reproduce
looking at the pattern of failures has been unsuccesful.
In the mean time, adding an option to issue full reconnect
when send data packet fails.
* typo
* Do NACKs and reports always.
With padding packet drops, it is possible that a lot of packets
go by without RTCP RR.
Do NACKs and RTCP RR always.
* remove local variable
Seeing the case of a stream starting with padding packets
on migration. As publisher in that case is always sending packets.
it is possible that the new node gets padding packets at the start.
Processing them in buffer leads to trying to drop that padding packet
and adding an exclusion range. That fails because the extended
sequence number is not available for unprocessed packets.
It is okay to drop them as they will be dropped anyway.
But, they are useful for bandwidth estimation. So, headers are processed
even if the packet is RTPStats unprocessed.
* Handle duplicate padding packet in the up stream.
The following sequence would have produce incorrect results
- Sequence number 39 - regular packet - offset = 0
- Sequence number 40 - padding only - drop - offset = 1
- Sequence number 40 - padding only duplicate - was not dropped (this is
the bug) - apply offet - sequence number becomes 39 and clashes with
previous packet
- Sequence number 41 - regular packet - apply offset - goes through as 40.
- Sequence number 40 again - does not get dropped - will pass through as 39.
* fix duplicate dropping
* fix tests
* accept repeat last value as padding injection could cause that
* use exclusion ranges
* more UT and more specific errors
* Remove sender report warp logs.
They are not useful.
Also replacing drift report with proper protocol and reporting
both packet ad report drift.
Need to dig more into out-of-order sender report sending.
That requires some digging and understanding.
* record time of anachronous report
* more logging around out-of-order repair
* log time of out-of-order received sender report
* Update deps and place holder StartParticipantEgress
* Drop padding only packet on publisher side.
* add UT
* update deps
* remove debug
* add fast path short cut
* correct comment
* fix test
* fix for Linux
When restoring state, reference layer could change before this change.
That meant the time stamp base would change and cause jumps.
But, the solution in this change to store the reference layer state
and restoring it has a different issue. It is possible that the reference is
layer 2 (HIGH) for example. On a migration when the down track has
to re-attach and resume to a moved up stream track, it is possible that
layer 2 is not published due to bandwidth constraint after publisher
migrates to new node. In that case, the stream cannot be resumed as
time stamp adjustment cannot be calculated.
An option is to set referenceSpatialLayer always at layer 0 (LOW).
But, that also has a couple of issues
- Browsers like FF have shown issues with layer mapping.
- Layer 0 is lowest bit rate. So, it will have RTCP at lower frequency.
That could introduce a slight latency in stream start as we need
RTCP sender report to calculate the time stamp.
Open to ideas on how to handle this better.
