It was possible that the adjustment applied in the middle
of a frame resulting in the same frame having multiple time stamps.
That would have caused video to pause/jump.
Apply the offset only at the start of the frame so that all
packets of a frame get the same offset.
* RTCP sender reports every three seconds.
Ideally, we should be sending this based on data rate.
But, increasing frequency a little as a lost sender report
means the client may not have sender report for 10 seconds
and that could affect sync. We do receiver reports once a second.
Thought of setting this to that level too, but not making a big change
from existing rate.
Also, simplifying the RTCP send loop. Don't need to hold and
do the processing after collecting all reports.
* consistent use of GetSubscribedTracks
* Experimental flag to try time stamp adjustment to control drift.
There is a config to enable this.
Using a PID controller to try and keep the sample rate at expected
value. Need to be seen if this works well. Adjustment are limited
to 25 ms max at a time to ensure there are no large jumps.
And it is applied when doing RTCP sender report which happens
once in 5 seconds currently for both audio and video tracks.
A nice introduction to PID controllers - https://alphaville.github.io/qub/pid-101/#/
Implementation borrowed from - https://github.com/pms67/PID
A few things TODO
1. PID controller tuning is a process. Have picked values from test from
that implementation above. May not be the best. Need to try.
2. Can potentially run this more often. Rather than running it only when
running RTCP sender report (which is once in 5 seconds now), can
potentially run it every second and limit the amount of change to
something like 10 ms max.
* remove unused variable
* debug log a bit more
* Keep track of expected RTP time stamp and control drift.
- Use monotonic clock in RTCP Sender Report and packet times
- Keep the time stamp close to expected time stamp on layer/SSRC
switches
* clean up
* fix test compile
* more test compile failures
* anticipatory clean up
* further clean up
* add received sender report logging
* Keep track of expected RTP time stamp and control drift.
- Use monotonic clock in RTCP Sender Report and packet times
- Keep the time stamp close to expected time stamp on layer/SSRC
switches
* clean up
* fix test compile
* more test compile failures
With subscription manager, there is no need to tell a publisher
about a subscriber going away. Before subscription manager,
the up track manager of a participant (i. e. the publisher side)
was holding a list of pending subscriptions for its published tracks
and that had to be cleaned up if one of the subscriber goes away.
That is not the case any more.
Also set publisherID early so that subscription permission update has
the right publisherID. In fact, saw an empty ID in the logs and saw
that we still have the disallowed subscription handling which is not
necessary any more.
* hopefully more stable tests
* do eventual checks as some callbacks happen in go routines.
Needs a bit more work to ensure that some conditions do not happen.
But, with goroutines, the amount of wait is always tricky.``
data.
Without the check, it was getting tripped by publisher not publishing
any data. Both conditions returned nil, but in one case, the receiver
report should have been received, but no movement in number of packets.
Raja Subramanian