The samples before the first level change were counted as bits, and where no
edge arrives inside ten clocks the long-run flush fired first and invented ten
of them out of the quiet lead-in. The count sat on a rounding boundary, so one
sample of jitter in that edge added or dropped a leading bit and rotated the
rest of the word - while startIdx, derived from the same count, held i % clk and
could name no sample.
A level change can only fall on a bit boundary, so start there and report it.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
GetT55xxBlockData extracted every block at config.offset, a bit index into a
demod buffer cached by the last detect - a different capture. Demodulators do
not all start on the same bit, so a later read could return a rotation of the
block with nothing marking it as wrong: psk1 by four or five bits, fsk2a and
nrz by one, manchester and biphase never.
Record the boundary where it is stable instead. Every demodulator reports the
graph sample its first bit sits on, and turn_read_lf_on(137 * 8) makes the
firmware open each read acquisition at the same point, so the word boundary
lands on the same sample every time. Convert back per demodulation.
Block 0 re-anchors from its known value, and a write is now verified by the
value being anywhere in the repeating stream rather than at one cached offset -
which also fixes correct writes reporting as validation failures. A block 0
verify re-detects on a mismatch, not only on a decode failure: the pre-write
config can decode the post-write signal into garbage rather than failing.
Also fixes a -1 password sentinel truncated to 32 bits by a ternary, which made
that detect report a password that was never supplied.
Measured on a T5577 across psk1, fsk2a and direct/nrz: three consecutive dumps
agree field for field, against a baseline where psk1 corrupted 22 of 24.
Co-Authored-By: Claude Opus 5 (1M context)
Send a synchronous zero-length packet after CDC responses whose length is
an exact multiple of the endpoint packet size, preventing oversized host
reads from remaining pending.
# Updates
1. Updated `MEGACASH` vendor name from `Bank Mega` to `PT Bank Mega Tbk` *which is the vendor's full name*.
-r&y.
Signed-off-by: ry4000 <154689120+ry4000@users.noreply.github.com>
# Updates
1. Updated `Fermax` AID to reflect the parent company's name/country and DESFire PACS product.
Signed-off-by: ry4000 <154689120+ry4000@users.noreply.github.com>
# Updates
1. Changed `type` from `e-amusement` to `arcade` for:
- Bandai Namco Passport
- Konami e-amusement pass
- Sega Aime
- Taito NESiCA
2. Updated `description` to include the full name and `(AIC)` annotation to note that this information only applies to the Amusement IC Card variants as opposed to MFC/ICODE SLI/MFC/MFU, respectively.
-r&y.
Signed-off-by: ry4000 <154689120+ry4000@users.noreply.github.com>
